The notebook was purchased after the 14th college entrance exam. After adding a memory stick and a solid state, it was always happy and safe. It was used a few days ago. However, when I was working hard to restore light to Al, it suddenly "It's time - the cooling fan on the back made a huge noise. MSI (msi) GE40 2PC-486XCN 14.1-inch Gaming Notebook (i5-4210MQ 4GB 1T GTX850M 2G 1920×1080) Black GE Series In the MSI gaming series, entry-level series, GE40 is even an entry-level model, the main cost-effective, products in To meet the basic game requirements, the price has a good advantage. Today recommended this GE40 2PC-486XCN 14-inch game, the use of i5-4210MQ processor, equipped with GTX850 graphics card, mainstream games can be competent, and the other 4G memory later need to expand their own capacity, 1T hard Jingdong Direct link Encyclopedia At first, I thought it was a heat sink and accumulated dust. However, after opening it was found that there was no dust. After the simple processing, I put the fan back. As a result, the boot didn't reach 30S, and I started to roar again. It made me feel suddenly. From the bedroom to the tractor, I couldn't stand it. Baidu found out that my fan might be lacking in lubricants. Then he took the initiative and bought! Tb shopping As soon as I couldn't keep up with the eyes of roommates (good) (nu), the courier finally arrived and the following began to prepare for the dismantling. Take a look at computers and equipment: Notebook A side D surface It can be seen that the stickers on the D side have been damaged. This was broken long before adding the memory and the solid state. It is also necessary to clear the gray once every six months or so. But the big advantage of MSI is that the integrity of the sticker does not affect the notebook's warranty (hey, your laptop has long been guaranteed!), so you can do it yourself. The battery is removed first, and the external battery will not forget this, but if it is a built-in battery, it should be powered off before performing other operations. Then open the back cover. The cover needs to use a crowbar or a lap. These guys are: It is best not to use a metal boring bar, because the hardness is high, it is easy to scratch the plastic shell, so I chose the blue plastic crowbar in the picture. Of course, you must remove the screws on the back before you open it. . If you don't unload the screw, it may break the backboard. After removing the backplane, you can see the fan. The hard disk was originally a 1T mechanical hard disk. It was replaced by an optical drive. I gave this position to Gutian, and the black memory was added to the Samsung Dark Knight 4G. I think about it like this. It was at the time of the last high memory price that I missed the low period. Remove the remaining two fan retaining screws to kill the fan horse. The figure above is the tool that I originally expected to use. The figure below is the tool I actually use. How can it be totally different? The reason is here. I thought there was a screw under the sticker. The result did not expect that the sticker could not be removed. . So you can only use metal crowbars that you didn’t use before. Quote Archimedes's famous quote: Give me a fulcrum, I can shake the earth. There is no fulcrum for the fulcrum here, so I had to take my thumb as my fulcrum, and it was a little bit sore. . To open the backplane is the fan blade, Baidu is magnetically attracted, the overlord bowed the hole from the back of the hole against the fan leaves, vigorously out of the miracle will be able to separate: Then just put a little bit of grease on the bearing. Then put the fan back in reverse and put it on the screw and add the back panel to put the battery and the power supply to connect the monitor. Fine, you can enjoy using the silky smooth silent notebook to brush the aunt.
