Low-voltage switchgear fever, don't panic, teach you a few tricks

The most troubled thing in summer is a "hot" word, air conditioning is everyone's essential equipment for summer heat. Then the electrical products themselves need to be dissipated. For example, the notebook we use works in such a high temperature environment in summer, and the loss of heat will cause damage to the notebook. This time the notebook cooler can effectively improve this problem.

Notebooks need to dissipate heat, and we must also dissipate heat from low-voltage switchgear. Earlier we talked about the cause of the heat of the low-voltage switchgear. Today we are talking about how to solve this problem.

It is well known that the heat of the switchgear in summer is a big problem in the operation of the power system. It affects the normal production operation of the enterprise. We start from the aspects of power distribution design, operation mode, operation and maintenance, etc. Well, the heat problem of the low voltage switchgear can be solved.

First of all, we must strengthen the system planning and design and equipment selection:

When planning and designing the system, it is necessary to carry out sufficient load statistics, load growth prediction analysis, and capacity to meet the load growth demand. The selected switchgear equipment should meet the relevant national standards, and all types of switchgear equipment that are forbidden to be produced and used are not used. When producing the switchgear, reserve enough overcurrent capacity to minimize the heat of the hair in the switchgear during operation.

Second, establish a standardized maintenance and repair system:

Products should be tested and inspected, strictly in accordance with the relevant standards of the state and the power industry, and unqualified cannot be used. The operating performance of each component of the switchgear should be checked in real time according to the relevant requirements, and the contact surface of the contact should be seen for discoloration or oxidation.

Finally, we must standardize the industrial process of overhaul and improve the quality of maintenance to ensure the excellent performance of the equipment.